Description
[Powerful FULL Featured Spectrum Analyzer] - WOOKLEA tinysa ultra, produced by Hugen, is installed with the latest hardware system V0.4.5.1. Now have new firmware V0.4.5.1.1 - Updated LCD screen for availability reasons. With the new ESD protection function, tiny sa ultra has a higher anti-static level and a longer service life. Handheld frequency analyzer great for a portable, alternative to bulky test equipment.[Widely Measure Range] - Tiny sa ultra spectrum analyzer has a wider measurement range, from 100kHz to 5.3GHz, spectrum analyzer for 100kHz-800MHz and Ultra mode up to 6GHz, can observe signals up to 12GHz. Don't need to switch frequency ranges - reads from 100 KHz to 800 MHz.[Intuitive Controls] - With 4 inch touch screen (480*320 pixels resolution) is enough to see what you need. Color display showing max 450 points providing gapless covering up to the full frequency range. Switchable resolution bandpass filters from 200Hz to 850kHz. This displays frequencies up to 5.3 GHz WiFi ranges, helping you visually identify optimal access point placement and assess Faraday shielding effectiveness.[Spectrum Analyzer & Signal Generator in ONE] - Tinysa ultra is a high-bandwidth real-time spectrum analyzer based around an SDR. It also as a signal generator that works at a wide range of frequencies. As a spectrum analyzer: UlTRA mode - up to 5.3G, High Performation - 100kHz to 800MHz. As a RF signal generator, 100kHz - 800mhz sine wave output, 800MHz - 4.4GHz square wave output, 4.4GHz - 5.4GHz mixing signal output.[PC Control Available] - Connected to a PC via USB, transfers data directly to the computer. The USB interface realizes the CDC protocol and is capable of executing a wide range of commands via the serial interface. These command can be used to perform measurements or update internal settings. The driver for Windows will install automatically after connecting to a Windows PC. The driver for Linux is built into the kernel.[Built-in 3000m-ah Battery] - Equipped with a 3000mAh rechargeable lithium battery, which can be fully charged within 3 hours using the type-C charging cable and features an LED charging indicator. The RF electronics in the tiny sa ultra heavily rely on an adequate level of supply voltages. For best performance ensure the battery level is above 3.9 Volt.[What You Get] - 1x Tinysa ultra Spectrum Analyzer host (with 4 inch display, 3000mAh battery); 2x 30cm/11.8cm ALSR100 SMA cables; 1 x USB Type-C data cable; 1x SMA-SMA barrel connector; 1x Antenna with SMA connector; 1x 32GB MicroSD card(plugged in the host), 1x stylus pen; 1x TLanyard and touch plectrum
