Description
ใ๐๐ฅ๐จ๐ฐ ๐ข๐ง ๐ญ๐ก๐ ๐๐๐ซ๐คใlt contains fluorescent materials that can glow in the dark after absorbing light energy. Compared to similar products on the market, Anycubic Glow-in-the-dark PLA Filament has a brightness increase of 300% and a 150% increase in glow duration under the same lighting conditions. We recommend you to expose the prints to a full of sunlight or UV light for a period of time..ใ๐๐๐๐ฎ๐ซ๐๐๐ฒ & ๐๐จ๐ง๐ฌ๐ข๐ฌ๐ญ๐๐ง๐๐ฒใ Anycubic 3D Printer PLA filament of 1.75mm diameter, Minimum dimensional tolerance ยฑ0.02mm, which makes filament outflow smoother, came out homogeneous. The low shrinkage and stable printing dimensions make the fusion between the layers very good to obtain an even better-bridging result. You don't worry the diameter changes a lot then the feed rate is disrupted with thicker and thinner layers at all..ใ๐๐๐๐ญ ๐๐ฉ๐จ๐จ๐ฅ & ๐๐ซ๐๐ฆ๐ข๐ฎ๐ฆ ๐๐ฎ๐๐ฅ๐ข๐ญ๐ฒใ The 3D Printing PLA filament was neat on the roll and easily left the spool without crossing turns. Resulting in less thread pulling and twisting, no clogging, and super under-extruding. It produces the cleanest, least stringing prints of any of the filaments you have used while resisting warping and providing the glossiest finish. Without a single jam and adhesion issue which meets your demands for printing freely..ใ๐๐ฅ๐จ๐ -๐ ๐ซ๐๐ & ๐๐ฎ๐๐๐ฅ๐-๐ ๐ซ๐๐ใ Designed and Manufactured with a Clog-Free patent to guarantee a smooth and stable printing experience with our PLA refills. Completely dried for 24 hours before packaging and vacuum sealed with desiccants in nylon re-bag enable much smoother and more stable printing. The larger spool inner diameter design makes feeding smoother..ใ๐ ๐ข๐ฅ๐๐ฆ๐๐ง๐ญ ๐๐ง๐ฌ๐ญ๐๐ฅ๐ฅ๐๐ญ๐ข๐จ๐งใ 1. Install the spool on the spool holder of a 3D printer, and preheat the nozzle of the 3D printer. 2. Cut the filament tip diagonally, and guide it through the extruder and feeding tube. 3. Manually push the filament through the feeding tube to the nozzle, until the filament melts through the nozzle. Note: When installing and changing filament, we highly suggest preheating the nozzle first to reduce the nozzle block risk.
