Description
【BATTERY CHECK ANALYZERS】 EDITORIAL RECOMMENDATIONS Batteries Tester. FOXWELL BT705 auto battery life testers designed for 12 V or 24 V batteries with a capacity of 100 to 2000 CCA, such as regular flooded, AGM flat plate, AGM spiral, GEL and deep cycle batteries, 12V & 24V starting and charging system. The test results based on JIS, EN, DIN, SAE, CCA, BCI, GB, CA, MCA and IEC Standards..【CAR BATTERIES DOCTOR】 Adopt the advanced conductance testing technology, the premium quality copper clip and wire maintain a stable communication all throughout the testing process to provide you with reliable results! Accurately and quickly measure the actual cold cranking amps, capability of the vehicle starting battery and healthy state of the itself. Test results are not limted to SOH, SOC, CCA , current, rating, resistance, no-load & loaded voltage, charging ripple value, etc..【CRANKING & CHARGING SYSTEM TEST】 BT705 car battery testers displays the decision on the starter system, cranking voltage and cranking time in milliseconds. Also, the battery diagnostic scan tool can check 12 volt or 24 volt vehicle electronic system’s charging condition to make sure the output voltage of the generator is in a regular condition, the rectifier diode works fine and the charging current is a normal status..【TOP ABS BLEED SCAN TOOL】The air will get inside when replace components such as calipers, wheel cylinders, the master cylinder, brake lines or hoses. This abs auto bleed scan tool will help bleed the brake, cycling the pump and valves to get a firm brake pedal and keep a safety driving on the road. Own a foxwell obd2 scanner with abs auto bleed function is so valuable instead high cost from the dealships. 👉Note: Only works on the vehicles have auto abs bleeding..【ALL FUNCTIONS FOR ABS VSA SRS AIRBAG】Do more for ABS VSA SRS Airbag system not just reading/clearing codes like other scan tools do. The abs scanner airbag code reader is born to solve issues when the warning light(MIL) was on. Diagnoses, pin-points the problem down and tells you which sensor was bad that caused the problem, no need to replace one by one. NT630 plus will reset/calibrate the new sensor after replacement. Finally turning off the warning lights and keeping all to running well.
