Description
Three phase DC brushless with Hall motor controller, need motor with Hall to work properly. Brushless motor driver board, high power PLC. This driver is only for DC brushless with Hall motor with electric angle 120 degrees..New upgrade BLDC wide voltage 6-60V high power 350W, DC three-phase brushless with Hall controller, support PLC 0-5V touch volume control, support PWM control amplitude 2.5-5V..The main board power supply circuit without fuse, can be added(by yourself), the power supply positive and negative terminals will cause permanent damage to some of the chips on the board (not even for a few seconds when the high current).Motor output for sampling overcurrent protection, due to the module power supply current are very large. Do not artificially cause a short circuit in the normal operation of the module, a short circuit will damage the tube. Wiring test machine for small-current low-voltage test, successful then through the high-current high-voltage . Bare board module, pay attention to wire insulation when wiring, forbid strong voltage to touch the board..Do not connect the obvious and drive module voltage, current, power phase does not match or far from the motor to avoid inexplicable "nonsense" damage.
