Description
[INITIALIZATION SETUP] We have to finish the initialization setup by the following 2 steps: 1st we have to check the detailed room temperature and diamond size,find the Initial value of our test.you can find the detailed table on the back of the diamond tester pen. 2nd we have to turn the wheel to set the Initial value.eg if the size of diamond is small than 0.05ct, and the temperature is more than 30 degrees Celsius,then set the Initial value as 7, it means you have to turn the weel and keep 7 lights on. Otherwise you won't get a acuracy result..[TWO HANDS OPERATION] All test must be done by TWO hands, one for hold the diamond and one for the diamond tester. As for the hand which hold diamond tester, you have to touch the electricity conductive panel on the back of the unit.If you test the diamond just by one hand, you will get a wrong result.[CAN'T DISTINGUISH MOISSANITE]: This diamond testing pen is just a entry-level pen for amateur. So it can only help you distinguish between diamonds and imitation gemstones, but it cannot distinguish between natural diamonds and laboratory-grown diamonds (Also Called Moissanite)..[FOR DIAMOND]:For testing diamond(include real diamond and Moissanite), it will emits beeping-beeping-beeping in a low frequency, 1 time/second. Meanwhile lights ≥ 9 (Notice: the bigger the stone is, the more lights on).[CAN'T TEST METAL]: Please never use this diamond testing pen test metal!.[WARM NOTICE 1]: Please make sure the ambient temperature is not lower than 10 degrees Celsius when in use, and shut down promptly when not in use..[WARM NOTICE 3]:The contacts need to be pressed vertically against the surface of the diamond..[WARM NOTICE 3]: Don't wear gloves when you have a test.[WARM NOTICE 4]: We will be always on hand when you have problems.Also you can check the manul.
