Description
1. The difference between P0 and P1 versions: P0 is the self-locking mode. For example, if you press the external forward switch (K1), the motor will always keep forward. It will not stop until the reverse signal (K2) or the forward stop signal (SW1) is encountered. P1 is the jog mode. For example, when the external forward switch (K1) is pressed, the motor will rotate forward. When K1 is released, the motor will stop running immediately..2. The signal is active at low level and can be connected to a three-wire sensor (NPN-NO type); K1, K2, SW1, and SW2 still have this specification..3. The limit signal is valid in P1 jog mode. For example, when K1 has a signal, it will rotate forward at this time, but there is also a signal at the limit of SW1, and it will stop at this time (it will not rotate forward)..4. The limit signal can also be called a stop signal. The limit signal is of trigger type and level enable function. For example, if a short limit signal is encountered during forward rotation, it will stop, even if the limit signal disappears, it will still stop. The forward rotation signal must be repeated again to be forward again..5. Can not realize automatic forward and reverse rotation without timing function, so strictly speaking, it cannot automatically reciprocate. But with the start switch, start switch (A), end switch (B), it can realize infinite reciprocating operation between A and B. Connection: start switch and start switch are connected to K1, end switch is connected to K2, SW1 and SW2 are not connected. Note that all switches are normally open.
